GE 20621 - Manual (Page 7)

7
Code Search
If your device does not respond after you have tried all the codes
for your brand, or if your brand is not listed, try searching for your
code by following these steps.
1. Manually turn on the device ( TV, DVR, etc.) to be controlled.
2. Press and hold the SETUP button until the red
indicator stays on, then release the SETUP button.
3. Press and quickly release the desired device button
( TV, DVR, etc.). The red indicator blinks off once.
4. Press the ON-OFF button repeatedly (up to 300
times) until the device to be controlled turns off. The
red indicator blinks off with each button press.
. Press and release ENTER to install the code.
Most users will store DVR codes under the DVR button,
Cable codes under CABLE, etc. If (for example) you want
to store a DVR code under CABLE, first follow the procedure
for Direct Code Entry (previous page) and press CABLE in
step 2 of Direct Code Entry, then enter ANY DVR code in
step 3 of Direct Code Entry. Then follow the steps above for Code
Search.
Note: Code Search starts from the currently stored 4-digit number
under that mode. Sometimes the first code that “works” with
your device may only allow limited functionality (e.g., the MENU
button might not work). There may be a code that performs more
functions. Continue the code search process until the best code is
found.