Grizzly G8976 - Manual (Page 17)

G8976 3 Wheel 12" Bandsaw -15-
7. Slide the blade slot in the table around the
blade (
Figure 12) and position the table trun-
nion against the back of the bandsaw.
Figure 12. Attaching the table to the bandsaw.
8. Secure the table/trunnion assembly to the
bandsaw with the two knob bolts that were
removed in
step 5, (Figure 13).
9. Re-insert the phillips screw that was
removed in
step 3.
Figure 13. View of the table/trunnion assembly
attached to the body of the bandsaw.
To assemble the miter gauge:
1. Slide the “peg” on the bottom of the miter
body into the hole centered on the miter bar.
2. Secure the miter body to the miter bar with
the M6-1.0 x 15 knob bolt, (
Figure 14).
Figure 14. Assembled miter gauge.
Miter Gauge
!
Trunnion
Blade Slot
Knob Bolt
Table