GPX PD808B - Manual (Page 8)

8
Playing a DVD
1. Plug the unit into a standard 10V outlet, and turn the power on by moving the Power
Switch into the ON position. If the internal battery is charged, the unit does not have
to be plugged in.
. Press the Open Button and load a DVD into the unit’s DVD-Drive. Close the DVD
Door, and the DVD will start automatically.
. If the DVD doesn’t start, switch the unit to DVD Mode by pressing and holding the
DVD/SD/USB Function Button.
4. Use the Directional Buttons to navigate through the DVD menu.
5. Press the Play Button or Enter Button to make selections in the DVD menu.
6. Press the Pause Button to pause a DVD during play.
7. Press the Previous & Next Buttons to skip backwards and forwards through DVD
chapters.
8. Press the Menu Button to go back to the DVD’s main menu.
Programming a DVD
1. Insert a DVD into the unit. See the
“Playing a DVD” operation on page 16.
. After the DVD is inserted and loaded,
press the Program Button on the remote
control to display the Program Menu.
. Use the Directional Buttons to move
through the sixteen different program
slots.
4. Highlight a slot and enter a Title (T)
number and Chapter (C) number using
the Number Keypad on the remote
control. Repeat steps and 4 until
the desired titles and chapters are
programmed.
5. Highlight the “Play” button, on screen,
using the Directional Buttons, and press
the Enter Button to begin playing the
programmed titles and chapters.
T R K 1 8 / 1 8 0 1 : 1 4 : 2 0
PROG
PLAY CLEAR
T C T C T C T C
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
--:-- --:-- --:-- --:--
--:-- --:-- --:-- --:--
--:-- --:-- --:-- --:--
--:-- --:-- --:-- --:--
DISPLAY SETUP
AUDIO TITLE
TFT ON/OFF
DISPLAY A A SETUP
AUDIO TITLE
TFT ON/OFF
DVD
PREV. NEXT
DVD/SD/USB PLAY/PAUSE
VOLUME
OPEN