Cleaning, Automatic clean function – GE 681131692090 User Manual

Page 14

Client:

PIL (Wal*Mart)

Project:

169209

Language: EN

Date:

13.07.2009

Version:

Page:

(of 18 pages)

CLEANING

Automatic clean function

The coffee maker is equipped with an automatic clean function. After 60 brewing cycles,
the

clean indicator/button (21) lights up. This indicates that the coffee maker should

be cleaned using the automatic clean function and the charcoal filter

(16) should be

replaced.

NOTE: The coffee maker can continue to be used, when clean indicator/button (21)
is on.

•

To begin the cleaning cycle, remove the charcoal filter

(16) from the water tank (9). Fill the

tank with a vinegar and water mixture (½ vinegar and ½ water) or a descaling product.

•

Press and hold

clean button (21) for 2 seconds to start program. The coffee

maker beeps once before cleaning starts. The

clean button (21) flashes while the

program is running.

•

Press and hold the

clean button (21) for 3 seconds to stop program once it has

started.

•

Press button

(29) anytime during clean cycle to stop program and allow the unit

to start to brew.

•

After completion of cleaning program or if power is lost during clean cycle, the
counter is reset, and the

clean button light (21) will go out.

Cleaning process:
•

Continuous cycles of 7 seconds brewing and 21 seconds off until tank is empty.

•

After cleaning process is complete the

clean

indicator/button

(21) goes off.

Fill water tank

(9) with clean water and run one brewing cycle to rinse the coffee

maker.

•

Change the charcoal filter

(16) (ill. k ). Reinsert the charcoal filter into the coffee

maker (ill. l ).

NOTE: You can use the cleaning function before reaching 60 cycles by following the
steps above (especially if the water hardness in your area is above normal).

NOTE: Replacement water charcoal filters and carafes are available at WAL-MART stores.

CM-169209-17 (EN).indd 14

7/13/2009 5:09:18 PM

This manual is related to the following products:

169209