Grizzly G9859 - Manual (Page 19)

Ultimate Series Jointers -17-
To adjust the infeed table:
1. The infeed table can be adjusted the same
way as the outfeed table. Loosen the infeed
table lock knob in the center of the handwheel.
2. Place a straightedge on the outfeed table so it
hangs over the infeed table. Turn the cutter-
head so that the knives are
NOT touching the
straightedge.
3. Loosen the infeed table lock knob. Raise the
infeed table until it just touches the straight-
edge as shown in
Figure 13 . Tighten the table
lock knob.
4. Adjust the depth of cut scale to read “0”.
Infeed Table
Figure 13. Setting the depth of cut scale.
90° Fence Stop
1. Place a square on the outfeed table fairly
close to the cutterhead as shown in
Figure
14 .
Figure 14. Use of square to align fence.
2. While holding the fence adjusting handle,
loosen the angle setting lock knob and the
checknut on the 90° stop screw as shown in
Figure 15. Turn the stop screw against the
sliding bracket until the fence contacts the
edge of the square evenly.
3. Tighten the checknut on the stop screw and
tilt the fence back, then forward against the
stop.
4. Recheck with the square. Tightening the
checknut will move the stop bolt slightly, so
some trial-and-error may be necessary to
perfect your settings.
Figure 15. Setting the 90° stop.
90° Stop