Stovax Riva Plus Midi Wood & Multi-fuel - Manual (Page 7)

7
UseR INsTRUCTIoNs
5.3 Experience establishes settings to suit personal preferences.
PR8035 Opti Burn Position
Position 1: Full Running
Position 2: Opti-Burn
Adjust left to reduce output
• Lowest heat out put for burning wood (Opti Burn). This
position helps keep the glass clean, Diagram 9
Shut Down Position
PR8027
• Lowest possible heat out put for burning wood. This
position does not keep the glass clean, Diagram 10
5.4 Do not burn large amounts of fuel with the Airwash control
closed for long periods of time. This reduces the glass
cleaning effect and causes tars and creosotes to build-up in
the appliance and flue system.
5.5 When in use, burning the appliance at high output for a
short period each day also reduces tars and creosote.
5.6 Multi-fuel stove:
The Solid Fuel setting is from the Centre to the Left
The Wood burning setting is from the Centre to the Right
Once the fire becomes established:
• Move the control from the wood start up position, See
Diagram 6, to the Multi-fuel position on the left, Diagram
11
PR8032
• Minimum position for burning solid fuel, Diagram 11
PR8035
• Maximum position for burning sold fuel. This position
helps keep the glass clean.
A de-dent ball will locate the arm in the correct position see
Diagram 12.
5.2 De-ash the fire bed before re-fuelling, See Ash Removal
• Open the Control fully to establish a glowing bed before
adding new fuel
• Burn new fuel at high output for a few minutes before
adjusting the Control to the desired setting
• Refuel little and often for clean, efficient burning.
5.3 Experience establishes control settings to suit personal
preferences.
Full Heat Position PR8036