GE Monogram built-in 42 - Manual (Page 16)

16
Drawer
and pan
removal To remove a drawer or pan:
1. Pull the pan out to the stop position.
2. Lift the front of the pan up and out of
the wire holder.
3. Lift the back of the pan up and out.
To replace a pan:
1. Place the back of the pan in the wire
holder, making sure the wire holder fits
into the grooves on the back of the pan.
2. Lower the front of the pan into the wire holder.
3. Press firmly on the top of the pan to snap it
into the wire holder.
Climate Control Drawer and Storage Pans
Built-In Refrigerators
Drop down
shelf The drop-down shelf gives you the use
of another full-size shelf when you need extra
storage. It conveniently folds back out
of the way when not in use, giving you room
for storage of larger items.
To use drop down shelf:
1. Pull forward and down to drop the shelf
into place.
2. Pull forward while lifting up to place the shelf
out of the way.
Lighted
vegetable
drawer
cover The lighted vegetable drawer cover provides
lighting for the lower compartments. The lights
are recessed into the cover to illuminate
the drawers below.
To remove cover:
1. Remove the top drawer (see Drawer and pan
removal section).
2. Remove the thumb screw located inside
the front left corner under the cover.
This screw is in place so the cover cannot
be accidentally dislocated while in use.
3. Lift the cover and carefully pull forward
to expose the plug.
4. Unplug the cover and carefully remove it from
the refrigerator.
To replace cover:
1. Carefully set cover onto the side rails, leaving
the plug exposed.
2. Plug the cover into the refrigerator.
3. Carefully slide the cover into place.
4. Replace the thumb screw under the front edge
of the cover.
5. Replace the drawer (see Drawer and pan
removal section).