Grizzly H6086 - Manual (Page 21)

Model H6082, H6083, and H6086 Heirloom Electric Guitar Kits -19-
Components Needed Qty
Guitar ................................................................. 1
Truss Rod Cover ............................................... 1
Tap Screw M2 X 12 ........................................... 1
Tools Needed
Drill with a
1 ⁄
16
" Drill Bit ....................................... 1
Depth stop ......................................................... 1
Phillips Head Screwdriver .................................. 1
To install the nut:
1. Center the truss rod cover over the hole for
the truss rod and press it up against the nut.
2. Use 1 ⁄
16
" drill bit to drill 3 ⁄
8
" holes through
the hole in the truss rod cover and into the
peghead.
3. Secure the truss rod cover to the peghead
with the tap screw.
Truss Rod Cover
Figure 30. Installing the locking nut.
Components Needed Qty
Guitar ................................................................. 1
Floyd Rose Locking Nut .................................... 1
Tap Screw M3 X 12 ........................................... 2
Tools Needed
Narrow Chisel or Razor Blade ............................1
Drill with a
3 ⁄
32
" Drill Bit ........................................1
Depth Stop .........................................................1
Phillips Head Screwdriver ..................................1
To install the nut:
1. Use a chisel or razor blade to scrape any fin-
ish out of the nut slot. DO NOT remove any
wood from the nut slot.
2. Center the locking nut in the nut slot.
3. Drill 3 ⁄
8
" deep holes through the two holes
shown in Figure 30.
Attaching the Nut on
the Model H6086
4. Thread two screws through the locking nut
and into the neck.
Note—The remaining lock blocks and cap screws
will be installed after the guitar is tuned.