Genie TML-4000N - Manual (Page 4)

2 Genie TML-4000 and TML-4000N Part No. 97600
Operator's Manual Third Edition • Second Printing
Fall Hazards
Do not stand on the
machine.
Do not climb on the mast.
Tip-over
Hazards
Do not raise the mast to the vertical position unless
all outriggers are properly deployed, the foot pads
are in firm contact with the ground and the machine
is level.
Do not set the machine up on a surface where it
cannot be leveled using only the leveling jacks.
Do not hang any objects from the lights or mast.
Do not use the mast to raise material or personnel.
Do not move the machine unless the mast is
lowered to the horizontal position and securely
locked in place.
Do not extend the mast when wind speeds may
exceed 60 mph / 27 m/sec.
Do not place ladders or scaffolds against any part
of the machine.
Do not alter or disable machine components that in
any way affect safety and stability.
SAFETY RULES
Do not adjust or stow the outriggers when the mast
is raised.
Do not use the machine on a moving or mobile
surface or vehicle.
Be sure the tires are in good condition and the lug
nuts are properly tightened.
Electrocution Hazards
This machine is not electrically insulated and will
not provide protection from contact with or
proximity to electrical current.
Maintain safe distances away from electrical power
lines and apparatus in accordance with applicable
governmental regulations and the following chart.
Voltage Minimum Safe
Phase to Phase Approach Distance
Feet Meters
0 to 300V Avoid Contact
300V to 50KV 10 3.05
50KV to 200KV 15 4.60
200KV to 350KV 20 6.10
350KV to 500KV 25 7.62
500KV to 750KV 35 10.67
750KV to 1000KV 45 13.72
Allow for mast movement and electrical line sway
or sag, and be aware of strong or gusty winds.
Do not operate the machine during lightning or
storms.
Do not use the machine as a ground for welding.