GE Monogram ZV48 - Manual (Page 8)

8
Light bulbs The bulbs are located on the underside of
the hood.
To change the light bulbs:
1. Remove the trim ring by turning it
counterclockwise.
2. Grasp the bulb on the edges and remove
by turning it counterclockwise.
3. Replace with the same type and size bulb.
These 120 volt, 50 watt, par 16 halogen flood
bulbs, with standard base, are available at
specialty lighting stores.
These bulbs can also be ordered from your
GE supplier.
Order bulb no. WB08X10028.
Care and Cleaning
Professional Range Hood
Warming
lamps The warming lamps are located on the
underside of the hood.
These 120 volt, 175 watt, par 38 infrared heat
lamp bulbs, with standard base, are available
at some specialty lighting stores.
These infrared bulbs can also be ordered
from your GE supplier.
Order bulb no. WB08X10029.
NOTE: If warming lamps are not desired,
additional cooktop lighting can be obtained
by replacing the infrared bulbs with standard
incandescent bulbs with up to 100 watt
maximum ratings, with standard bases. These
bulbs are available at specialty lighting stores.
Do not use a steel-wool pad; it will scratch the
surface.
1. Shake bottle well.
2. Place a small amount of CERAMA BRYTE ®
Stainless Steel Cleaning Polish and
Conditioner on a dry cloth or dry
paper towel.
3. Clean a small area (approximately 8
″ x 8″),
rubbing with the grain of the stainless steel
if applicable.
4. Dry and buff with a clean, dry paper towel
or soft cloth.
5. Repeat as necessary.
To order:
To order CERAMA BRYTE ® Stainless Steel
Cleaning Polish and Conditioner, please call
our toll-free number:
National Parts Center . . . . . . . 800.626.2002
www.GEAppliances.com
CERAMA BRYTE ®
Stainless Steel Cleaning
Polish and Conditioner . . . . . . . # PM10X313
Stainless
steel surfaces
(on some
models)