Stovax Logic Hotbox & Convector Fire - Manual (Page 6)

USER INSTRUCTIONS
COAL LAYOUT
NOTE: THERE ARE TWO LARGE COALS IN A BAG INSIDE
THE MAIN BAG. THESE ARE ONLY TO BE USED WHEN A
CURVED FRONT SUCH AS THE HOLYROOD AND
RICHMOND ARE USED. DO NOT USE THE TWO LARGE
COALS WHEN USING A FLAT FRONTED FRAME.
A) FRONT ROW COAL LAYOUT USING FLAT FIRE FRONTS
7.6 The front row is the only difference in coal layout. Place one
large coal centrally on the front coal resting against
the frame. Then place three small coals either side.
See diagram 8.
B) FRONT ROW COAL LAYOUT USING CURVED FIRE
FRONTS.
7.7 Place three large coals resting on top of the front coal and
against the front of the frame, then place two small coals
either side of the large ones. See diagram 9
C) COAL LAYOUT CONTINUED FROM FRONT ROW
7.7 Place four large coals behind the first row and one small
coal either end resting up against the side panels.
See diagram 10
7.8 Place one small coal either side on top of the flame baffle in
each rear corner. Then place two large coals in between the
two small coals. These coals should touch the rear panel.
See diagram 11.
7.9 Finally place five large coals between the second and rear
row of coals. See diagram 12.
7.10 It is essential that gaps are left between the coals to maximise
the performance of the appliance.
8
9
10
11
12
6