GE Monogram ZDIB50 - Manual (Page 7)

CARE AND CLEANING
Periodically inspect and clean the icemaker to keep it
operating at peak efficiency and to prevent premature
failure of system components.
Both the icemaking system and the air-cooled
condenser need to be cleaned regularly.
The minerals rejected from the circulating water
during the freezing cycle will eventually form a hard
scaly deposit in the water system which prevents a
rapid release of the ice from the freezing plate.
Clean the ice and water system periodically to remove
mineral scale build-up. Frequency of cleaning
depends on water hardness. With hard water (15 to 20
grains/gal.), cleaning may be required as frequently as
every six months.
A dirty or clogged condenser:
• prevents proper air flow.
• reduces icemaking capacity.
• causes higher than recommended operating
temperatures which may lead to component failure.
Cleaning Outside Surfaces
Wash the outside enamel surfaces and gaskets with warm water and mild
soap or detergent. Rinse and dry. Regular use of a good household
appliance cleaner and wax will help protect the finish.
Do not use abrasive cleaners on enamel surfaces as they may scratch
the finish.
Cleaning the Condenser
1. Disconnect the electrical power supply to the
icemaker and turn the Cycle Control Knob to “OFF.”
2. Remove the screw from the top of the lower access
panel and the two screws from the grille area of the
lower access panel.
3. Pull forward at the bottom, then down to remove
the panel.
4. Remove dirt and lint from the condenser fins and
the icemaker compartment with a brush attachment
attached to a vacuum cleaner.
5. Replace the lower access panel and screws. The
top of the access panel needs to be secured under
the two metal tabs before replacing the screws.
6. Plug icemaker in and turn the Cycle Control Knob
to “ON.”
(continued next page)
WARNING:
• Be sure the icemaker is OFF and
disconnected from the main power
supply. The icemaker could suddenly start if
not disconnected. Condenser fan rotation,
sharp condenser fins and hot tubing could
cause personal injury.
• Condenser fins can bend easily. Use care
when vacuuming the condenser to keep from
bending the fins.
7
Screw
Lower
Access
Panel
Grill
Area
Screws