Speeds and timer – Grizzly G9956 User Manual

Page 14

-12-

G9956 Heavy-Duty Hanging Air Filter

-12-

Speeds and Timer

You can adjust the fan speed and the length of
time your double air filter runs by programing it
with the included remote controller. To toggle
between fan speed and timer control functions,
press the ON/HR button.

To set the fan speed:

1. Press the ON/HR button once. The fan

should start to run.
—If one or more of the lower lights comes

on, press the ON/HR again.

2. Increase the fan speed by pressing the

increase button designated by the right hand
pointer.

3. Decrease the fan speed by pressing the

decrease button designated by the left hand
pointer.

To set the fan timer:

1. Press the ON/HR button after setting the fan

speed.
—If some or all of the lights in the upper row

come on, press the ON/HR button again.

2. Increase the amount of time the fan runs

before automatically shutting off by pressing
the increase button.
—Each time this button is pressed, the

amount of time increases by two hours,w
up to a maximum 8 hour cycle.

3. Decrease the amount of time the fan runs

before automatically shutting off by pressing
the decrease button.

NOTE—When the automatic shut off feature is
not going to be used, press the decrease button
until the light over “continue” is illuminated.

ON/HR

OFF

CONTINUE

HOUR

SPEED

Figure 7. Lights indicate a fan speed of 3.

Increase

Decrease

Figure 8. Light indicates time set for 6 hours of

operation.