Garmin zumo 550 en - Manual (Page 10)

zūmo 500/550 Owner’s Manual
G
ettinG
S
tarted
A) To install the U-bolt and handlebar
base:
1. Place the U-bolt around the handlebar,
and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do
not overtighten.
notE: The recommended torque
is 50in-lb. Do not exceed maximum
torque of 80in-lb.
B) To install the handlebar base to the clutch/brake clamp bracket:
notE: Both 1/4” standard
and M6 bolts are included.
Match the size of the
factory bolts on your
clutch/brake clamp bracket.
1. Remove the two factory bolts
on your clutch/brake clamp
bracket.
2. Thread the new bolts through
the handlebar base, spacers,
and clamp bracket.
3. Tighten the bolts to secure the base.
Handlebar
base
Handlebar
U-bolt
Clutch/brake
clamp bracket
Handlebar
base
Spacers