GE RM24941 - Manual (Page 8)

Code Identification
Code Identification allows you to find out what codes are programmed in the
remote under a given mode (TV, VCR, DVD, etc.).
1. Press and hold the SETUP key on the rubber keypad until the LED
indicator light remains on and the touchscreen shows the Main Setup
Screen. This process takes approximately 2-3 seconds.
2. Release the SETUP key.
3. Press and release the LCD CODE key. The LED indicator light blinks once
to indicate acceptance of the keypress.
4. The touchscreen now shows Device Setup Screen. Press and release the
device key on the rubber keypad for the device whose code you want to
identify (TV, VCR, SAT/CBL, etc.). The LED indicator light blinks once to
indicate acceptance of the keypress.
5. The touchscreen now shows the Code Setup Screen. Press and release the
SETUP key. The LED indicator light blinks once to indicate acceptance of
the keypress.
6. The touchscreen now shows the Code ID Setup Screen (initially blank
except for LCD SETUP, INFO and CODE keys). The touchscreen then
shows the code, using the LCD digits. The digits in the three-digit code
are shown in sequence for one second each, followed by a 0.5 second gap
where no digits are shown. The LED indicator light blinks once for each
digit display. The sequence is completed once and then the touchscreen
returns to the Main Setup Screen.
7. The Code Identification process is now complete. You can write this Code
ID in the Code ID Chart for easy reference.
Code Identification Chart
Enter your codes here for easy reference:
TV CODE
VCR CODE
SAT/CBL CODE
DVD CODE
AUX 1 device: AUDIO
Tuner ❒ AMP ❒
Tape ❒
AUX 2 device:
CD CODE
6
24941manual 8/13/03 8/19/03 8:42 AM Page 8