Stovax Riva Nemos 8627 MA - Manual (Page 5)

5
USER INSTRUCTIONS
5. CLEANING THE NEMOS
ENSURE THE APPLIANCE IS COLD BEFORE PROCEEDING.
5.1 The outside casing of the Nemos should be cleaned using a
damp cloth. If you have a stainless steel door version, it
should be cleaned using a stainless steel cleaner.
5.2 To clean the burner system, firstly depress the front door
centrally on the RH side and the door will release allowing
you to open fully. See diagram 1.
1
AR1287
5.3 Remove the glass panel by unscrewing the nine pozidriv
screws. See diagram 2.
2
AR0816
5.4 Remove the ceramic logs and place on a dry, clean surface.
It is not essential to remove the embers.
5.5 The logs should not require cleaning. Do not use a vacuum
cleaner or brush to clean the logs, any large pieces of debris
may be removed by hand.
5.6 Ensure any debris is removed from the burner ports.
5.7 Replace the ceramics and door by referring to section 6.
5.8 To clean the glass surface, Gazco recommends you use a
ceramic glass product generally sold for cleaning ceramic
hobs.
6. ARRANGEMENT OF FUEL BED
COMPONENTS
ADVICE ON HANDLING AND DISPOSAL OF FIRE
CERAMICS
The fuel effect and side panels in this appliance are made
from Refractory Ceramic Fibre (RCF), a material which is
commonly used for this application.
Protective clothing is not required when handling these
articles, but we recommend you follow normal hygiene
rules of not smoking, eating or drinking in the work area
and always wash your hands before eating or drinking.
To ensure that the release of RCF fibres are kept to a
minimum, during installation and servicing a HEPA filtered
vacuum is recommended to remove any dust accumulated
in and around the appliance before and after working on it.
When servicing the appliance it is recommended that the
replaced items are not broken up, but are sealed within
heavy duty polythene bags and labelled as RCF waste.
RCF waste is classed as stable, non-reactive hazardous waste
and may be disposed of at a licensed landfill site.
Excessive exposure to these materials may cause temporary
irritation to eyes, skin and respiratory tract; wash hands
thoroughly after handling the material.
6.1 Place log A on to the burner. Ensure the rear of the log
touches the rear of the burner. See diagram 3.
AR0816
3
CENTRALISE THE LOG BETWEEN THE BURNERPORTS AT
EITHER END
Four of the remaining logs have location holes on the
underside. These locate on the studs at the front of the fire.
6.2 Place log D on the third stud from the left and resting at the
rear of log A. See diagram 4.