Stovax Riva Nemos 8627 MA - Manual (Page 12)

12
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
3. INSTALLATION OF THE APPLIANCE
NOTE: THERE IS AN OPTIONAL CONVECTION FAN KIT
AVAILABLE CODE No. 8576. THIS CAN BE FITTED EITHER
DURING OR AFTER INSTALLATION, BUT PROVISION
FOR A POWER SUPPLY MUST BE MADE PRIOR TO
INSTALLATION OF THE APPLIANCE.
3.1 Remove the front of the wooden crate by undoing the four
bolts, two at each side. See diagram 1.
1
AR1288
3.2 Remove the front of the crate and place to one side. See
diagram 2.
2
AR1289
IMPORTANT: ENSURE THAT THE APPLIANCE IS
CORRECTLY ADJUSTED FOR THE GAS TYPE AND
CATEGORY APPLICABLE IN THE COUNTRY OF USE.
REFER TO DATABADGE AND TECHNICAL
SPECIFICATIONS ON PAGE 8.
LPG MODELS: THE APPLIANCE IS FACTORY SET TO RUN
ON BUTANE (G30). IF IT IS INTENDED TO BE USED ON
PROPANE (G31) THE AERATION PLATE SUPPLIED MUST
BE FITTED.
TO CHANGE AERATION PLATE REFER TO SECTION 9,
SERVICING INSTRUCTIONS.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES
REFER TO SECTION 10, SERVICING INSTRUCTIONS.
1. CONTROL UPGRADE
1.1 This appliance is fitted with a control valve that can be
easily upgraded to battery powered remote control. There
are two versions of this control which can be obtained
through your local Gazco stockist.
1.2 This upgrade can be fitted before or after installation. Full
instructions are included with the kit.
1.3 STANDARD REMOTE CONTROL This remote control can
control the gas appliance after the pilot has been lit. It can
turn the main burner on and regulate it from low through to
high and back again. It can turn the main burner off leaving
the pilot burning. GAZCO PART NUMBER 8455.
1.4 THERMOSTATIC AND TIMER REMOTE CONTROL This
remote control can control the gas appliance after the pilot
has been lit. In 'MANUAL MODE' it can be used to turn the
main burner on and manually regulate it from low through
to high and back again. It can also be used to turn the main
burner off leaving the pilot burning. In 'AUTO MODE' it will
automatically regulate the room temperature. In 'TIMER
MODE' it will turn the fire on and off according to a pre-set
programme and automatically regulate the room
temperature during two on periods. GAZCO PART
NUMBER 8456
2. SAFETY PRECAUTIONS
2.1 This appliance must be installed in accordance with the
rules in force, and used only in a sufficiently ventilated
space. Please read these instructions before installation and
use of this appliance.
2.2 These instructions must be left intact with the user.
2.3 Do not attempt to burn rubbish on this appliance.
2.4 In your own interest, and those of safety, this appliance
must be installed by competent persons in accordance with
local and national codes of practice. Failure to install the
appliance correctly could lead to prosecution.
2.5 Keep all plastic bags away from young children.
2.6 Do not place any object on or near to the appliance. Allow
adequate clearance above the appliance.
INSTALLATION INSTRUCTIONS
INSTALLATION