Special features of your control, Special features, Of your control –1 – GE Monogram MONOGRAM ZEK755 User Manual
Page 9: Special features of your oven control, Tones at the end of a timed cycle, Attention tone
9
The control has a series of tones that will sound at different times. These
tones may sound while you set the control for an oven function or at the
end of the oven function. They will also alert you when an incorrect time
or temperature has been entered or if there is a problem with the oven.
Tones While Setting the Control
Preheat Notification Tone
When you press a touch pad you will hear a beep.
This beep will let you know you have placed enough
pressure on the pad to activate it.
When you set an oven temperature the oven
automatically starts to heat. When the temperature
inside the oven reaches your set temperature a tone will
sound to let you know to place the food in the oven.
Tones at the End of a Timed Cycle
At the end of a timed cycle, 3 short beeps will
sound followed by one beep every 6 seconds, until
CLEAR/OFF is pressed. This continuous 6 second
beep may be canceled.
To cancel the 6 second beep:
1. Press the upper oven BAKE
and BROIL HI/LO at the
same time for 2 seconds
until the display shows “SF.”
2. Press KITCHEN TIMER ON/OFF.
The display shows “CON BEEP”
(continuous beep). Press KITCHEN
TIMER ON/OFF again. The display
shows “BEEP.” (This cancels the one
beep every 6 seconds.)
3. Press START.
NOTE: This cancels the end of cycle tone for
both ovens.
BAKE
KITCHEN
TIMER
ON/OFF
B R O I L
HI/LO
BAKE
SPECIAL FEATURES OF YOUR OVEN CONTROL
Your new touch pad control has additional features that you may choose
to use. The following are the features and how you may activate them.
The special feature modes can only be activated while the display is
showing the time of day clock.
They remain in the control’s memory until the steps are repeated. When the
display shows your choice press START. The special features will remain in
memory after a power failure.
Attention Tone
This tone will sound if you set an invalid function or try to set an additional
function. The tone can be quickly identified by watching the display messages.