beautypg.com

Mounting the antenna, Installing the voltage converter unit, Installing the power and network cables – Garmin GMR 606 User Manual

Page 4

background image

GMR 600/100 Series Installation Instructions

Mounting the Antenna

1. Remove the protective cover from the pedestal wave guide.
2. Verify that the antenna wave guide is aligned with the pedestal wave

guide. Slide the antenna onto the pedestal.

3. Secure the antenna to the pedestal using the 8 mm hex bolts, flat

washers, and spring washers. The 8 mm bolts should be torqued to

70 lbf-in (6 lbf-ft) (.81 kgf-m).

Installing the Voltage Converter Unit

The included voltage converter unit is needed to supply a specific constant voltage to the radar. When installing the voltage converter unit,

consider the following:

The voltage converter requires an input voltage of 10–40 Vdc (20–40 Vdc for the GMR 1204 and GMR 1206).
You must connect the converter to the boat battery through a 15 A slow-blow fuse.
Garmin recommends that you install the voltage converter as close as possible to the selected

power source.
For optimal performance, connect the voltage converter housing to the RF ground of the vessel.
If the input wires need to be extended, follow the recommendations in the wire gauge table.

If the wires are extended, use the supplied heat-shrink butt connectors.
After the connector is crimped, heat the connector to shrink it and provide a water resistant fit.

Voltage Converter Unit

+

-

15 A slow-blow fuse

To radar

To RF ground

To power

10–0 Vdc

(0–0 Vdc for

the GMR 1204

and 106)

GMR 600/100 series

Voltage Converter Unit

Sample boat fuse block

Connecting the Voltage Converter to a Boat Fuse Block

Installing the Power and Network Cables

Route the cable as needed, based on the type of mount you are using.
When installing the power and network cables, consider the following:

To ensure safety, use the appropriate tie-wraps, fasteners, and sealant to secure the cable along a route and through any bulkhead or deck.

Avoid running the cable near moving objects, high-heat sources, or through doorways and bilges.
Avoid installing the cable next to or parallel to other cables, such as radio antenna lines or power cables. This is essential to avoid

interference to or from other equipment. If this is not possible, shield the cable with metal conduit or a form of EMI shielding.
You may need to drill a 1

1

/

4

in. (31.7 mm) hole for routing the power/network cable. Garmin provides a rubber cable grommet to cover the

cable installation hole.

The grommet does NOT provide a waterproof seal. To waterproof the grommet, apply a marine sealant.
You can purchase additional cable grommets through Garmin or a Garmin dealer.

Use the optional field-installable RJ-45 network connector (included) to create a custom-length Garmin Marine Network cable if needed

(see

page 8

).






Align the

waveguide faces

Antenna

Pedestal

Align the

waveguide faces

Antenna

Pedestal

Wire Gauge Table

Distance

Gauge

9 ft. 10 in. (3 m)

12 AWG

16 ft. 4 in. (5 m)

10 AWG

21 ft. 3 in. (6.5 m)

9 AWG

26 ft. 2 in. (8 m)

8 AWG

Wire Gauge Table

Distance

Gauge

9 ft. 10 in. (3 m)

12 AWG

16 ft. 4 in. (5 m)

10 AWG

21 ft. 3 in. (6.5 m)

9 AWG

26 ft. 2 in. (8 m)

8 AWG

This manual is related to the following products: