GE 2-9755 - Manual (Page 6)

4
CHARGE
IN USE
PAGE / FIND
RINGER
OFF ON
VOLUME
PHONE CHANNEL SCRAMBLE
FLASH
3 2 1 DEF ABC
JKL MNO GHI
TUV WXY
4 6 5
9 8 7 PRS
TONE OPER # * 0
MEMORY REDIAL
W
ALL
M
OUNT
I
NSTALLATION
1
7
6
5
2
3
4
1. Install the base plate by putting
the tabs into the slots on the top
of the unit first, and then snapping
the bottom tabs into place.
2. Plug one end of the short tele-
phone line cord into the jack
marked PHONE LINE on the back
of the unit, and plug the other end
into a modular wall jack.
3. Connect the power supply adapter
to the POWER 9V DC jack on the
back of the unit, and plug it into an
AC outlet.
4. Slip the mounting holes over the
wall plate posts and slide the unit
down firmly into place. (Wall plate
not included.)
5. Set the TONE/PULSE switch to
TONE if you have touch-tone
service or to PULSE if you have
rotary dial service.
6. Turn on the RINGER switch so the
handset rings for incoming calls.
7. Place handset in the base to
charge for 12 hours. The CHARGE/
IN USE light comes on indicating
that the battery is charging.
2-9755 A CAN IB E 1 4/3/97, 5:21 PM 4