Global Machinery Company ATBR1650K - Manual (Page 11)

11
Preparing the tool
Tool lubrication
This finish nailer requires lubrication BEFORE initial use and
BEFORE and AFTER each additional use throughout its life.
1. Disconnect the air hose, turn the finish nailer so the air
inlet (3) is facing up. Place 3-4 drops of non detergent
oil into the air inlet. Do not use air tool oil as it
contains solvents which will damage the nailer’s internal
parts.
2. Lubricate the drive safety cover & slide guide (8),
trigger (2) and magazine slide mechanism periodically.
3. After lubrication, run brad nailer briefly. Wipe off any
excess oil from the adjustable deflector exhaust (1).
The work surface can become damaged by excessive
lubrication.
4. Finish nailer repairs must be done by a qualified and
experienced service dealer.
Apply a thin coat of
lightweight grease to
safety slide guides.
Apply a few drops of oil
to sliding mechanism of
the magazine.
Apply a few drops
of oil to the trigger
mechanism.
Place a few drops of
non-detergent oil into
air inlet before each use.