GE UPVH880 - Manual (Page 39)

Installation Instructions
REASSEMBLE DOOR ASSEMBLY
Turn the inner door
over and place on
a soft, protected
flat surface so that
the inner part is facing
down. Assemble
the chrome cover
to the inner door by
placing them together.
Flip the door assembly over and assemble, using
7 screws (#10 x 1.125
″
tapping screws).
5
7 x A Screws
REVERSE FRONT PANEL PLUG
BUTTONS AND STRIKE PLATE
Remove the 2 plug buttons on the dryer front
panel, using a putty knife or other flat tool as
shown, and reinstall on the opposite side. Switch
the strike bracket and its cover by removing
2 screws (#8 x 0.625
″
tapping screws) for each
and reinstalling on opposite sides.
6
Strike
bracket
2 Plug
buttons
39
REINSTALL DOOR ASSEMBLY
Place the door back on the dryer front panel,
making sure the latch is engaged and the hinge
is sitting in the two openings in the dryer front.
Assemble the door to the front cabinet, using
2 screws (#10 x 0.75
″
tapping screws).
Install 2 x B
screws
7
Install the new left-hand hinge cap (from the
reversibility kit) onto the hinge, by opening the
dryer door and screwing the hinge cap into place.
NOTE: Save the remaining caps and covers in case
you want to reverse the hinge again.
1 x C Screw
in hinge cap
Protective
piece of tape
NOTE: Apply a protective piece of tape to the side
of the plug button where the putty knife blade will
be inserted to prevent scratching.
Hinge cap