GN Netcom 5830 - Manual (Page 38)

35
Blind Call Transfer
If you have installed additional AT&T 5800 handsets
(purchased separately) with your 5830 telephone, you
can transfer a call from one handset to another.
From the Handset
1 Press , then use to highlight
were you want the call transferred.
2 Press when the desired destination
is highlighted.
3 Press
O or place the handset in the charger
to complete the transfer.
From the Base
1 Press I.
2 Press the number of the handset where you
want the call transferred (for example, 2).
¥
NOTE: An unanswered call will ring back to the
originating handset or base if not answered in
30 seconds.
Announced Call Transfer
1 Press to put the call on hold.
2 Press , then use to highlight
INTERCOM.
3 Press , then use to highlight
the call destination, then press again.
4 When the handset or base answers, announce
the caller.
5 Press
O on the handset or K on
the base to end the call.
6 Press
P (on the receiving handset) or
K on the base to pick up the call
on hold.
OK
OK
MENU
HOLD
OK
XFER
INTERCOM OPERA
TION
INTERCOM OPERA
TION
j j j
j j j p p p
k k k o o o
i i i i i
j j j
j j j
5830_CIB_1ATT 8/14/02 9:47 PM Page 35