Grizzly G8622 - Manual (Page 18)

-16- G8622 Tilting Spindle Sliding Table Shaper
Figure 19. Hold-downs on workpiece.
Figure 20. Installing the push shaft.
Figure 21. Installing the miter gauge.
Hold-Downs Miter Assembly
Hold-downs are used to hold the workpiece flat
on the table and snug against the fence as shown
in
Figure 19. To assemble the spring hold-
downs:
1. Slide a hold-down plate into each of the cast
iron hold-down brackets.
2. Insert the bracket pole into the fence bracket
and hold-down bracket.
3. Partially screw the handle into the hold-down
brackets.
4. Position the hold-downs according to the
size of your workpiece.
5. Tighten the handles to secure the hold-
downs.
The miter gauge for the Model G8622 features a
clamp and special fence. The miter gauge
assembly can be mounted on either end of the
table, depending on the type of desired cut or cut-
ting direction. To mount the miter gauge and its
fence:
1. Locate the threaded holes on either side of
the table.
2. Install the push shaft as shown in Figure 20 .
3. Now, slide the miter gauge down the push
shaft as in
Figure 21 .