GE DCVH680EJBB - Manual (Page 9)

Installation Instructions
9
IMPORTANT: Note the location of the hinge (left or right) before
removing.
8. With the door frame part of the door laid down on a
protected soft surface, remove the hinge cover by removing
the 2 tapping screws (#8) that fasten it to the frame. The
hinge cover is located at the opposite side of the hinge
assembly.
9. Remove the 2 nuts, washers, and the 2 machine screws (#8).
10. . Remove the hinge assembly by removing the 2 machine
screws (#8) that fasten it to the frame. Pull the hinge
assembly out and set it aside.
11. Place the hinge assembly in the opposite side of the door.
Align the hinge holes with the door holes.
REMOVE HINGE REINSTALL HINGE ASSEMBLY
12. Loosely fasten the hinge assembly to the edge using
2 machine screws (#8).
13. Hold the door on its side with one hand and fasten the
remaining 2 screws as shown. Then tighten the 2 screws
(#8) holding the hinge assembly.