Installation instructions, Before you start remove door assembly – GE DCVH680EJBB User Manual
Page 8
Installation Instructions
8
1. Unplug the dryer from its electrical outlet.
2. Open the door to approximately 90 degrees. Remove the 4
screws starting from the bottom to the top. Make sure the
door is supported while removing the screws.
3. Loosen the top screw as shown. Unhook the door by lifting
and pulling as shown by the arrows.
BEFORE YOU START
REMOVE DOOR ASSEMBLY
Remove the
four screws.
4. Lay the door down on a soft protected flat surface so that
the inner part faces upward (door resting on the handle side).
5. Remove the 6 large tapping screws (#10) located around the
perimeter of the door outlining the gasket and the 2 machine
screws (#8) on the hinge side.
6. With the screws removed, turn the door over and separate
the silver cover part of the door from the door frame and set
7. Unlock the 4 tabs on the plastic cover and separate the
plastic cover from the frame.
aside.
6 #10 Large
Screws
2 #8 Machine
Screws
2 #8 Machine
Screws
NOTE: Disregard the "DO NOT REMOVE" label on the plastic cover.