Garland JACK IN THE BOX XG36-JIB - Manual (Page 28)

Part # JIBSM08 Rev 7 (08/04/09) Page 28
To View the Flash Number:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press one, (1) time to display “PROGRAMMING MODE
SYSTEM INFO.”
5. Press four, (4), times to view the Flash Number. “FLASH
NUMBER X…X” is displayed. (Flash number varies by grill).
6. Press to return to “PROGRAMMING MODE SYSTEM
INFO”.
7. Press to exit.
To View the Software Number:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press one, (1) time to display “PROGRAMMING MODE
SYSTEM INFO.”
5. Press five, (5), times to view the Software Number.
“SOFTWARE NUMBER X…X” is displayed. (number varies
by grill).
6. Press to return to “PROGRAMMING MODE SYSTEM
INFO”.
7. Press to exit.
To View the Download Number:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press one, (1) time to display “PROGRAMMING MODE
SYSTEM INFO.”
PROGRAMMING
continued
5. Press six, (6), times to view the Download Number.
“DOWNLOAD NUMBER X…X” is displayed. (Download
number varies by grill).
6. Press to return to “PROGRAMMING MODE SYSTEM
INFO”.
7. Press to exit.
System Setup
To Change temperature Units, (°F or °C):
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times. “PROGRAMMING MODE SYSTEM
SETUP” is displayed.
5. Press to enter system setup. “TEMP DISPLAY
FAHRENHEIT (or CELSIUS)” is displayed.
6. Press to change the temperature units to either
Fahrenheit or Celsius.
7. Press to save the changes.
8. Press to return to “PROGRAMMING MODE SYSTEM
SETUP”
9. Press again to exit.
To Change Gap Setting Display Units:
1. Press and hold for three, (3) seconds. “ENTER CODE” is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
“ENTER CODE **** ” is displayed.
3. Press to enter the Programming Mode.
“PROGRAMMING MODE MENU ITEMS” is displayed.
4. Press two, (2) times. “PROGRAMMING MODE SYSTEM
SETUP” is displayed.
5. Press two, (2), times. “GAP SETTING DISPLAY INCHES
(or MILLIMETERS)” is displayed.
6. Press to change the Gap Setting Display units to either
Inches or Millimeters.
7. Press to save the changes.