GE RM94926 User Manual

Page 11

Programming For Audio

This remote control will operate many features found

in audio/video receivers and mini-systems. The

remote control is already programmed to operate most

GE, RCAand ProScan brand A/V receivers. Other

brands of receivers and mini-systems need to be set-

up under the AUDIO button prior to using the device.

1. Manually turn on the

device you wish to control.

Find the three digit code for

the device you wish to con-

trol in the code list below.

2. Press and hold the

CODESEARCH button

until the INDICATOR

LIGHT lights, then release

the CODE SEARCH button.

3. Press and release the

AUDIO button (The INDI-

CATOR LIGHT will blink

then remain lit.

4. Enter the code using the

Number Buttons. After your

code is entered, the INDI-

CATOR LIGHT will turn

off. If the code is not valid,

the INDICATOR LIGHT

will blink. Check the code

list and repeat process.

5. Aim the remote at the

device you wish to control

and press the ON•OFF but-

ton. The device should turn

off.

6. With your device on,

press VOL+ (Volume up). If

the device responds, no fur-

ther programming is

required.

NOTE: If your device does

not respond, try all the codes for your brand. If the

codes do not work, or your brand is not listed, try the

Code Search method on Page 16.

7. Enter your code and the type of device you

programmed here for easy reference.

94926 Revised Size 2/25/02 4:13 PM Page 11