Graco NUVI R NVI 200 - Manual (Page 10)

10 nüvi 00 Series set up and go! guide
Mounting on Your
Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard
and to comply with certain state
regulations.
iMPOrTaNT: The permanent
mounting adhesive is extremely
difficult to remove after it is
installed.
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
permanent mounting adhesive on the
bottom of the disk.
3. Place the disk on the dashboard.
4. Place the suction cup mount on
top of the disk. Flip the lever down
(toward the disk).
Changing the Fuse
CauTiON: When replacing the
fuse, do not lose any of the small
pieces and make sure they are put
back in the proper place.
If your unit will not charge in your
vehicle, you may need to replace the
fuse located at the tip of the vehicle
adapter.
1. Unscrew and
remove the silver
or black, round end
piece.
2. Remove the fuse (glass and silver
cylinder) and replace with a 1A fast
blow fuse.
3. Ensure that the
silver tip is placed
in the end piece.
Screw on the end
piece.
Unscrew
end
piece
silver tip
fuse