Graco ISPA113AB User Manual

Page 59

background image

• Combination Lap/Shoulder

Belt with Sliding Latch Plate

This belt has a latchplate that

slides freely along the belt.

This belt MUST be converted to prevent

movement of the lap portion of the belt. You

must use the locking clip provided with the

infant restraint, unless your vehicle's seat belt

can be converted in another way as described

in your vehicle owner's manual.

To Install Locking Clip:

1. Tighten the buckled belt by pushing

down hard on the infant restraint and

pulling hard on the shoulder belt.

2. While pushing down on infant restraint,

pinch the two straps together behind

the buckle tongue. Unbuckle the

belt without allowing it to slip.

3. Connect lap and shoulder belts

with locking clip as shown

➊

and

➋

.

4. Rebuckle belt. Check that lap

belt does not move by pulling

and pushing hard on infant

restraint. If belt loosens or

lengthens, repeat procedure.

Locking clip

½

inch

➊

Locking clip goes here,

1

/

2

inch from the buckle

➋

27