Gefen EXT-COMPAUD-CAT5-142 - Manual (Page 8)

5
SENDER PANEL DESCRIPTIONS
5V DC Power Input 1
Connect the included 5V DC power supply input this port. Once this has been
properly connected the power LED will become active.
3 RCA Component Input 2
Connect the component source device to this input.
2 RCA Analog Stereo Input 3
Connect the source’s analog audio to this input.
SPDIF Digital Audio Input 4
Connect the source’s SPDIF digital audio to this input.
Optical Digital Audio Input 5
Connect the source’s optical digital audio to this input.
Power LED Indicator 6
This LED will become active once the included 5V DC power supply is properly
connected.
RJ-45 Jack 7
Connect the sending and receiving units together using a TIA/EIA-568-B
terminated CAT-5, CAT-5e or CAT-6 cable. See page 10.
NOTE: Only one audio input type, digital or analog, should be connected at one time.