GE DPSB513 - Manual (Page 3)

■ Properly ground dryer to conform with all
governing codes and ordinances. Follow details
in Installation Instructions.
■ Install or store where it will not be exposed to
temperatures below freezing or exposed to
the weather.
■ Connect to a properly rated, protected and sized
power supply circuit to avoid electrical overload.
■ Remove the colored protective film from the
control panel.
■ Remove all sharp packing items and dispose of all
shipping materials properly.
Exhaust/Ducting:
Gas dryers MUST be exhausted to the outside.
Exhausting electric dryers to the outside is
strongly recommended to prevent large amounts
of moisture and lint from being blown into
the room.
Use only rigid metal or flexible metal 4
″
diameter ductwork inside the dryer cabinet or
for exhausting to the outside. USE OF PLASTIC
OR OTHER COMBUSTIBLE DUCTWORK CAN
CAUSE A FIRE. PUNCTURED DUCTWORK CAN
CAUSE A FIRE IF IT COLLAPSES OR BECOMES
OTHERWISE RESTRICTED IN USE OR DURING
INSTALLATION.
For complete details, follow the Installation
Instructions.
3
2
1
3
PROPER INSTALLATION
This dryer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting GEAppliances.com, or by calling 800.GE.CARES (800.432.2737).
Consumer Support
Troubleshooting T
ips
Operating Instructions
Safety Instructions
GEAppliances.com