Controls features, About controls features, Start – GE DPSB513 User Manual
Page 10: Stop, Estimated time remaining
10
Operating Instructions
Safety Instructions
Consumer Support
Troubleshooting T
ips
About controls features.
START
■
Press twice to select the last cycle you used and start the dryer.
■
If you have selected a new cycle, press once to start the cycle.
■
If the dryer is running, press once to interrupt the cycle; press again to continue
the cycle.
STOP
■
This pad should not be used to interrupt or pause a cycle.
■
Pressing this pad will cancel the current settings and the settings will be lost.
Estimated Time Remaining
Each time the dryer is used, it “learns” what types of loads you dry most often.
It takes this data and determines the approximate time it will take the load to dry.
As the cycle begins, you will see the approximate total cycle time in the display.
Then lights will flash in the display, and the SENSING light will flash. This means the
dryer is continuously monitoring the amount of moisture in the load. The lights will
continue until the dryer senses a low level of moisture in the load. At that point, the
dryer will calculate and display the approximate time remaining.
E
ST.
T
IME
R
EMAINING
E
ST.
T
IME
R
EMAINING