Sangean DPR-25+ - Manual (Page 13)

12
Operating your radio – Search tuning FM
1. Fully extend the telescopic aerial for FM reception.
2. Press and On/Off button to switch on your radio. The display will
show “Welcome to Digital Radio“.
3. Press the Band button to select the FM band.
4. Press and immediately release the Auto tune button, your radio will
scan in an upwards direction (low frequency to high frequency) and
stop automatically when it finds a station of sufficient strength.
5. After a few seconds, the display will update and may show the
station name (FM RDS).
6. To find other stations, press and release the Auto tune button
as before.
7. To scan the FM band in a downwards direction (high frequency to
low frequency), press and hold down the Auto tune button for
0.5 seconds and then release.
8. When the waveband end is reached, your radio will recommence
tuning from the opposite waveband end.
9. Adjust the Volume control to the required setting.
10. To switch off your radio, press On/Off button.
GB