GE 22 - Manual (Page 17)

Replace the Phillips head screw on both rail
assemblies.
Locate the slots on the inside of the rail
assemblies near the back.
Insert the hooks at the back of the railings
attached to the drawer, into the slots on the rail
assemblies.
Lower the front of the drawer, making sure the
tabs on the sides of the railing fit into the front
slots in the rail assemblies.
Replace the lower freezer basket. Make sure
the tabs on the sides of the basket fit into the
back notches in the rail assemblies and that
the lip on each side fits over the inside
section of the railings.
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
To Replace the Freezer Drawer
IMPORTANT: Two people may be required to complete
this procedure.
Pull out the rail assemblies to the full length on
each side of the cabinet.
Slot
Rail assembly
Slot
Tab
Hook
Phillips
Screw
Tab
Notch
Lip
17