GE 22 - Manual (Page 10)

10
Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
Care and cleaning of the refrigerator.
Preparing for Vacation
For long vacations or absences, remove
food and unplug the refrigerator. Move
the freezer control to the 0 (off) position,
and clean the interior with a baking soda
solution of one tablespoon (15 ml) of
baking soda to one quart (1 liter) of
water. Leave the doors open. Move the icemaker feeler arm (for
icemaker equipped models) to the STOP
(up) position and shut off the water supply
to the refrigerator.
If the temperature can drop below
freezing, have a qualified servicer drain
the water supply system (for icemaker
equipped models) to prevent serious
property damage due to flooding.
Preparing to Move
Secure all loose items such as grille, shelves
and drawers by taping them securely
in place to prevent damage. Be sure the refrigerator stays in an upright
position during moving.
Light Bulb Replacement
Turning the freezer control to the 0 (off) position does not remove power to the light circuit.
Behind the Refrigerator
Be careful when moving the refrigerator
away from the wall. All types of floor
coverings can be damaged, particularly
cushioned coverings and those with
embossed surfaces.
Pull the refrigerator straight out and return
it to position by pushing it straight in.
Moving the refrigerator in a side direction
may result in damage to the floor covering
or refrigerator.
When pushing the refrigerator back, make sure
you don’t roll over the power cord or icemaker
supply line.
Refrigerator Compartment
CAUTION: Light bulbs may be hot.
Unplug the refrigerator.
The bulbs are located at the top of
the refrigerator compartment.
To remove the light shield, remove the
screw at the back. Slide the shield back
and remove it.
Replace the bulb with an appliance
bulb of the same or lower wattage.
To replace the shield, line up the tabs
on the shield with the slots in the side
of the light assembly. Slide the shield
forward until it locks in place. DO NOT
force it past the locking point, since this
could damage the shield.
Plug the refrigerator back in.
Freezer Compartment
CAUTION: Light bulbs may be hot.
Unplug the refrigerator.
The bulb is located at the top of the
freezer compartment. To remove the
shield, push in on the tabs at the back
of the shield and pull straight out.
Replace with an appliance bulb of
the same or lower wattage.
To replace the shield, insert the tabs at
the front of the shield into the slots at
the front of the light assembly. Push the
back of the shield up until the back tabs
pop into place.
Plug the refrigerator back in.