GE 19230 User Manual
Page 5
5. Press the Push Button on to the back
cover by inserting the top of the Push
Button onto the top of the back cover
first and then pressing on the bottom
of the Push Button to snap the bottom
of the Push Button into place.
Installing the Chime Unit:
Note: Avoid mounting the Chime Unit on metal surfaces, as this may result in
reduced range of transmission. The Chime Unit should also be mounted no
farther than 150 feet from the Push Button.
1. Select a mounting location that is within the
150ft. range.
2. Use the supplied Chime template to mark
mounting holes.
a. If mounting to sheetrock:
i. Using a 5/32nd inch drill bit, drill holes at the marked locations.
ii. Insert the two wall anchors supplied
iii. Screw in the two screws supplied leaving a ¼” of the
screw extended out from the mounting surface. (See
diagram)
iv. Place the Chime Unit’s keyholes over the screws and gently press
downwards to secure Chime Unit.
b. If mounting onto or into wood:
i. Using a 1/16th inch drill bit, drill pilot holes at
the marked locations.
ii. Screw in the two screws supplied leaving a ¼”
of the screw extended out from the mounting
surface. (See diagram)
iii. Place the Chime Unit’s keyholes over the screws
and gently press downwards to secure Chime Unit.
1/4”
No further than 150 feet away