beautypg.com

Servicing instructions, Replacing parts, General – Stovax Clarendon & Ashdon ASHDON 8546LUC-P8546LUC User Manual

Page 22: Main burner, Pilot unit

background image

22

SERVICING INSTRUCTIONS

REPLACING PARTS

1. GENERAL

1.1 All principal components can be replaced without removing

the stove from its installation, although it is essential that the

gas supply to the appliance is turned off at the isolation

device before proceeding further.

1.2 If, for any reason, the flue has to be removed from the stove,

the seals must be replaced.

2. MAIN BURNER

2.1 Turn the gas supply off at the isolation device, remove the

door and place to one side, carefully remove the ceramic

fuel bed components.

2.2 Remove the three securing screws, two at the rear and one

at the front left hand side. See diagram 1. Raise the left hand

side of the burner to clear the bracket, draw the left hand

side forward. The burner venturi is engaged over the

injector. When removing the burner be sure to clear the

injector, this will release the right hand side of the burner.

Take care when removing the burner so as not to damage

the pilot burner.

2.3 To replace the burner, engage the venturi over the injector

ensuring the burner sits on top of the fixing bracket. Push

the burner to the right and whilst holding, insert the three

fixing screws.
NOTE: BEFORE REPLACING THE BURNER, ENSURE THE

SILICONE SEAL AROUND THE INJECTOR IS INTACT AND

CHECK THAT VENTURI COVER IS ATTACHED.

AR1605

1

3. PILOT UNIT

The pilot assembly consists of five components, which can

be individually changed, these are:
1) Pilot burner bracket
2) Pilot injector
3) Electrode
4) Thermocouple
5) Gasket.

3.1 Turn the gas supply off at the isolation device, remove the

door and place to one side, carefully remove the ceramic

fuel bed components

3.2 Refer to Section 2 to remove the main burner. Remove the

thermocouple baffle taking note of how it is positioned.

Refer to Diagram 2

3.3 Remove the two fixing screws from the pilot bracket, see

diagram 3. Gently draw the assemble away from the firebox

to give access to the nuts and ignition lead.
NOTE: TAKE CARE NOT TO DAMAGE THE GASKET.

AR1609

2

AR0614

3