GE DBB5000 - Manual (Page 8)

8
Operating Instructions
Safety Instructions
Consumer Support
Tr
oubleshooting T
ips
Reversing the Door
Tools needed:
■ Standard #2
■ Tape-tipped
Phillips screwdriver putty knife
Open the door and remove the filler plugs opposite the hinges. With the door
completely open, remove the bottom screw from each hinge on the dryer face.
Insert these screws about half way into the TOP holes, for each hinge, on the
opposite side (where you removed the filler plugs). Apply firm pressure to get
the screw started in new holes.
Loosen top screw from each hinge on the dryer face half way. With one hand
holding the top of the door and the other hand holding the bottom, remove
the door from the dryer by lifting it UP and OUT.
Rotate the door 180°. Insert it on the opposite side of the opening by moving
the door IN and DOWN until the top hinge and the bottom hinge are resting
on the top screws inserted in step 1.
Remove the remaining screws from the side of the opening from which the door
was removed. With these screws secure each hinge at the bottom. Tighten the
two top screws of each hinge. Reinsert the plastic plugs on the side from which
the door was removed.
4
3
2
1
About reversing the door.
About the dryer features.
Stainless Steel Drum (on some models)
The stainless steel used to make the
dryer drum provides the highest reliability
available in a GE dryer. If the dryer drum
should be scratched or dented during normal use, the drum will not rust or
corrode. These surface blemishes will
not affect the function or durability of
the drum.