GE 2-9751 - Manual (Page 6)

4
CHARGE
IN USE
PAGE / FIND
RINGER
OFF ON
VOLUME
CHANNEL
FLASH
3 2 1 DEF ABC
JKL MNO GHI
TUV WXY
4 6 5
9 8 7 PRS
TONE OPER # * 0
MEMORY REDIAL
PHONE
7
6
5
W
ALL
M
OUNT
I
NSTALLATION
1
2
3
4
1. Plug one end of the telephone line
cord into the jack marked PHONE
LINE on the back of the unit, and
plug the other end into a modular
wall jack.
2. Connect the power supply adapter
to the POWER 9V DC jack on the
back of the unit, and plug it into an
AC outlet.
3. Install the base plate by putting
the tabs into the slots on the top
of the unit first, and then snapping
the bottom tabs into place.
4. Slip the mounting holes over the
wall plate posts and slide the unit
down firmly into place. (Wall plate
not included.)
5. Set the TONE/PULSE switch to
TONE if you have touch-tone
service or to PULSE if you have
rotary dial service.
6. Turn on the RINGER switch so the
handset rings for incoming calls.
7. Place handset in the base to
charge for 12 hours. The CHARGE/
IN USE light comes on indicating
that the battery is charging.
NOTE: The easiest way to fit the telephone line
cord into the base plate, is to leave it wrapped
up. Just unwrap enough cord to reach the
PHONE LINE jack and the modular wall jack.