Grizzly G8145Z - Manual (Page 43)

-41-
g8144z/g8145z/g8146z
(Manufactured since 6/11)
Tensioning/
Replacing V-Belts
tensioning/replacing v-belts
to ensure optimum power transfer from the motor
to the blade without slipping, the V-belts must be
in good condition and operate under proper ten-
sion. Check V-belt tension at least every three
months—more often if the bandsaw is used daily.
V-belts stretch with use and must be periodically
re-tensioned.
replace the V-belts as a matched set if they are
cracked, frayed, or excessively worn.
To check/tension/replace the V-belts:
1. disCoNNECt BANdsAW FroM poWEr!
2. remove the rear motor access panel.
3. Make sure the motor and lower wheel pulleys
are correctly aligned.
4. push the center of each V-belt as illustrated
in figure 48, using moderate force. When
tensioned correctly, the deflection should be
about
3 ⁄
4
".
Pulley
Deflection
Pulley
figure 48. Checking for correct V-belt tension.
V-Belt Pulley
Alignment
the correct alignment of the motor and lower
wheel pulleys helps to ensure correct and even
tension of the V-belts, proper power transmission,
and reduced V-belt heat and wear during opera-
tion.
remove the rear motor access panel, and use
a straightedge across both pulleys, as shown in
figure 47, to check the pulley alignment.
if necessary, use a 19mm wrench to loosen the
two hex nuts securing the wheel pulley to its shaft,
align the wheel pulley with the motor pulley, then
re-tighten the hex bolts.
figure 47. Checking pulley alignment.
Wheel pulley
hex Bolts