Gemini GEM-P800 - Manual (Page 3)

3
Important - Test Your System Weekly !
1 Bell / Battery Test
Test your bell or siren by pressing followed by .
This will cause the bell, or siren to sound for 2 seconds
and also initiate a test of the battery .
2 Zone Test
Walk throughout the premises, opening each protected
door or window, and activating each motion sensor.
Check the keypad to see that each respective zone
number displays in the window.
3
Central Station Communication Test
(This test should only be performed on weekends or at a
time designated by your alarm company)
1 .Notify Central Station of the impending test.
2. Secure all zones to light Status Light on your keypad.
3. Enter your User Code followed by to Arm the system.
4. Violate your alarm by opening a window / door etc.
5. The siren or bell should sound and the system will send
the alarm signals to the Central Station
6 .Enter your User Code followed by to silence the alarm.
7. Call Central Station to insure that the alarm signals were
received properly.
Introduction
System Information
Central Station Phone Number: ____________________
Central Station Account Number: ____________________
For Service Call: ____________________
Entry Delay: ____________________
Exit Delay: ____________________
Alarm Time-out: ____________________
Table of Contents
Keypad Controls and Indicators ................................... 4
Arming your System (When Leaving) ........................... 5
Protecting Yourself While Home ..................................
6
Emergency Keys ....................................................... ... 7
Disarming the System .................................................. 8
Silencing an Alarm..................................................... .. 8
Resetting a Fire Alarm.................................................. 8
Fire Protection .............................................................. 9
Special Functions ........................................................ 11
System Troubles .......................................................... 12
Programming User Codes ............................................ 14
Glossary ....................................................................... 15
Oi219c
page 3 Tuesday, September 16, 1997 08:24