beautypg.com

System troubles – Gemini GEM-P800 User Manual

Page 12

background image

12

The GEM-P800 is constantly monitoring its own components, as well as all critical services, such as AC power and the telephone
line, to insure that it is always ready to provide the protection for which it was designed. When a system trouble does occur, it will
caution you by lighting the TROUBLE

light and beeping the keypad buzzer.

If you cannot immediately clear the system trouble, the system can still be used. Simply press

followed by

to view the

trouble as described below, and then arm the system.

To determine the nature of the trouble, press

followed by

, count the number of keypad beeps and observe the number

of the illuminated zone. Refer to the following table to determine the cause of the trouble. If there is more than one trouble to view,
pressing

will scroll to the next trouble, and then exit the TROUBLE

mode if there are no more troubles to view.

System Troubles

Keypad Beeps or

Flashes

Zone light

ON

System Trouble

Condition

Action

1

Beep

1

AC Power Failure

This trouble will occur if AC power is not present. Make sure system transformer is
plugged into AC receptacle and check the circuit breaker, otherwise call installing
company for service.

1

Beep

2

Low Battery

If there has been a recent power failure, the battery may be partially depleted and
must be recharged by the control panel. If the trouble does not go away in 24 hours,
call installing company for service.

1

Beep

3

Communication
Failure

The system was not able to report to central station. If this is due to a temporary inter-
ruption in the telephone service, the trouble can be cleared when the service is re-
stored by pressing

followed by

again to view the trouble, and and then

pressing

to exit. Otherwise, call installing company for service.

1

Beep

4

Telephone Line Cut

The telephone line has failed. If telephone service has been temporarily interrupted,
the trouble will clear it is when restored. Otherwise, call installing company for service.

2

Beeps

1

Bell/Siren Trouble

There is a problem with the Bell or Siren. Call installing company for service.

Oi219c
page 12

Tuesday, September 16, 1997 08:24