beautypg.com

Warning, Précautions, Installation – GE Monogram ZKD910 I User Manual

Page 7: Step 2 install warming drawer

background image

7

Installation

Warming Drawer

Step 1
Install
Anti-Tip
Brackets

Provide
Cabinet
Support

Important:

When installed below a single or double oven, check

to be sure that any oven supports above the cutout do not obstruct

the 23-1/2” required depth of the warming drawer cutout.

• A 2” min. clearance between oven and

warming drawer cutouts are required.
Additional clearance may be required if 2 x 4
blocks are used to support runners or solid
floor of the oven above.

• The warmer drawer may be supported by

either a solid bottom, 2 x 4 or 2 x 2 runners.

• The support must be level and rigidly

mounted, flush with the bottom edge of the
cutout.
– There is no way to level the drawer once it

has been installed. Be sure supports are
level.

• The entire weight of the drawer is supported

by the runners or solid floor and must be
capable of supporting 150 lbs.

Step 2
Install
Warming
Drawer

• Slide left corner of the drawer into the

opening.

• Push power cord into the hole leading to the

outlet location. Thread the cord through as
drawer is being pushed back into the open-
ing. Check to be sure power cord does not
get trapped under the drawer.
– If the outlet is installed inside the opening,

plug the cord into the outlet. Coil power
cord and secure to warming drawer side
with power cord clip.

• Push the drawer back until the front flange is

flush to the cabinet front.

• Open the drawer fully.
• Drill pilot holes through the holes in the

overlaping frame, one on each corner.

• Drive wood screws provided into each

corner.

23-1/2"

22"

27"

2"x 4" or
Equivalent Runners

23-1/2"

25"

30"

2"x 4" or
Equivalent Runners

9"

2x4 or 2x2

Runners or Solid

Bottom

Install

2x4 or 2x2

Anti-Tip Block

Against Rear

Cabinet Wall

9" From Floor

to Bottom

of Block

WARNING:

ANTI-TIP PRECAUTIONS
An anti-tip brace must be installed to prevent
the drawer from tipping forward when
opened and loaded. Failure to do so could
result in personal injury.

PRÉCAUTIONS

CONTRE LE BASCULEMENT
Pour éviter les blessures, il faut installer une
patte de retenue pour empêcher le tiroir de
basculer quand il est ouvert et plein.

This manual is related to the following products: