beautypg.com

Design information, Installation below wall ovens – GE Monogram ZKD910 I User Manual

Page 6

background image

6

Design Information

Warming Drawer

Installation
Below
Wall Ovens

When installed under a wall oven:
Warming drawers are approved for installation
below only certain specified wall oven models.
See the label attached to the top of the
warming drawer for approved models.
• When installed, the front face of the drawer

will be nearly flush with adjacent cabinetry
doors.

• Drawer overlaps will conceal cut edges on all

sides of the opening.

INSTALLATION

BELOW A

SINGLE OVEN

Note:

Additional clearance between

cutouts may be required. Check to be

sure that oven supports above the

Warming Drawer location does not

obstruct the required interior 23-1/2”

depth and 9-1/4” height.

Note:

Additional clearance between

cutouts may be required. Check to be

sure that oven supports above the

Warming Drawer location does not

obstruct the required interior 23-1/2”

depth and 9-1/4” height.

Dim. A

Dim. B

ZKD30

28-1/2”

30”

ZKD27

25-1/2”

26-3/4”

The rough opening for the drawer must be:

– Depth – 23-1/2” min. from inside back to

front of cabinet frame.

– Width – 25-1/2” for 27” wide models,

28-1/2” for 30” wide models.

– Height - 9-1/4”.
– Allow 2” min. between oven and drawer

cutouts for clearance of overlaps.

Note: If you are installing in frameless cabinets, it may
be necessary to install 1/2” wide cleats to accept
drawer mounting screws. See drawer for mounting
screw locations.

INSTALLATION

BELOW A

DOUBLE OVEN

1" Min. Above Toekick or Adjust
to Oven Installation Height

A

2" Min.

Allow 5/8"
Overlap on
All Sides

B

10-1/2"

23-1/4"

23-1/2" Min.

Inside

Oven

Cutout

9-1/4"

2x2 or 2x4
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block

9"

A

2" Min.

Allow 5/8"
Overlap on
All Sides

B

10-1/2"

23-1/4"

23-1/2" Min.

Inside

1" Min. Above Toekick

Oven

Cutout

2x2 or 2x4
Anti-Tip Block
Against Rear
Wall, 9" From
Floor to
Bottom of
Block

9"

9-1/4"

This manual is related to the following products: