Grizzly H8172 - Manual (Page 11)

H8172 Cement Mixer -9-
Assembly
To assemble the cement mixer:
1. Insert the wheels on the axles and secure
them in place with the hairpin cotter pins, as
shown in
Figure 3.
�������
����������
������������
�����
Figure 3. Wheels installed on axles.
2. Attach the support leg to the frame with two
M8-1.25 x 65 hex bolts on one side and two
8mm flat washers, lock washers, and hex
nuts on the other side (
Figure 4).
��������
������������
���������������
���������������
���������������
Figure 4. Support leg installation.
3. Connect the upper and lower plunger rods
together with an M6-1 x 25 hex bolt and M6-
1 lock nut, then insert the cotter pin where
shown in
Figure 5. Bend each leg of the cot-
ter pin outward so it can't fall out.
��������
���������
�����
�����������
�����
�����������
����������
��������
����
Figure 5. Plunger rod installation.
4. Attach the axle bracket to the frame with two
M8-1.25 x 65 hex bolts on one side and two
8mm flat washers, lock washers, and hex
nuts on the other side (
Figure 6).
��������
������������ �����������
���
�����������
���
�������
�������
Figure 6. Attaching axle bracket to frame.