beautypg.com

Determining an installation location, Wiring the gfl 10 adapter, Wiring the gfl 10 adapter to an analog gauge – Garmin GFL 10 User Manual

Page 2

background image

GFL 10 Installation and Configuration Instructions

Determining an Installation Location

When you are selecting a location to install the GFL 10 adapter, consider the following:

During installation, you connect the GFL 10 adapter to the analog gauge (or directly to the

fluid-level sensor), and to the NMEA 2000 network. Therefore:

Choose a location that is within 173 in. (4.4 m) of the analog gauge (or the fluid-level

sensor) to avoid splicing bare wires.
Choose a location between the NMEA 2000 backbone and the analog gauge (or the fluid-

level sensor).
If you cannot connect the adapter directly to the NMEA 2000 network, add a drop cable.

See

page 3

for more information.

The adapter is IEC 60529 IPX7 waterproof, and can be submerged up to 30 minutes at 1

meter. Do not install the adapter in a location where it will be submerged regularly, though

the location can be subject to wash-down.
You can use cable ties (not included) to secure the adapter to an existing structure on your

boat.
You can use mounted-head cable ties (not included) and screws (not included) to secure the

adapter to a bulkhead or other suitable surface on your boat.
Install the adapter at least 2 in. (5 cm) from a magnetic compass to prevent electromagnetic

interference, which can cause inaccurate compass readings.

Wiring the GFL 10 Adapter

Connect the GFL 10 adapter either to an analog gauge or to the sender directly using the bare

wires on the wiring harness.

Wiring the GFL 10 Adapter to an Analog Gauge

If your boat has an analog gauge representing the fluid level, you can wire the GFL 10 adapter

directly to the gauge. Consult the owner’s manual provided by your boat or sensor manufacturer

to determine the ground, sensor, and power (ignition) connections on the gauge. Typically,

the power (ignition) connector is labeled with a “+”, a “+12V”, an “I”, or an “IGN” marking.

The ground connector is typically labeled with a “-”, a “ ”, or a “G” marking, and the sensor

connector is typically labeled with an “S” or a “G” marking. Do not remove any wires from the

back of the gauge, and wire the GFL 10 adapter to the gauge according to the following table.

Wiring the GFL 10 Adapter Directly to a Fluid-Level Sensor

If your boat does not have an analog gauge representing the fluid level, you can wire the adapter

directly to the fluid-level sensor. Consult the owner’s manual provided by your boat or sensor

manufacturer to determine the sending and ground terminals on the sensor. Typically, the

sending terminal is labeled with an “S” marking for sensor or a “G” marking for gauge, and the

ground terminal is typically labeled with a negative sign (-). Wire the GFL 10 adapter to the

sensor according to the following table.