GE PTDS650GMWT - Manual (Page 8)

Installation Instructions
8
PLATE
(KIT WE1M454)
13 CHANGING DIRECTION OF
DOOR OPENING
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
• Insert the elbow through the rear opening and connect
it to the dryer internal duct.
• Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 7.
ADDING COVER PLATE TO REAR OF
CABINET
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate (Kit
WE1M454) available from your local service provider.
Place dryer in final location.
WARNING-
NEVER LEAVE THE BACK
OPENING WITHOUT THE PLATE.
CAUTION:
Internal duct joints must be secured with tape,
otherwise they may separate and cause a
safety hazard.
ROTATE DOOR 180°
AND REINSTALL.
REMOVE 4
HINGE SCREWS.
REMOVE 4 HOLE PLUGS AND
PLACE THEM IN THE HOLES
ON THE OPPOSITE SIDE.