Gravely 89201800 User Manual

Page 15

3. Make sure all shields are in place and in good

condition. Repair or replace any missing or damaged
shields.

4. Perform lubrication per paragraph 4-2.
5. Listen for abnormal sounds, which might indicate

loose parts, damaged bearings, or other damage.
Correct any deficiency before continuing operation.

6. With the engine off, engage the blower assembly.

Check the belt tension and inspect the pulley belt for
cracks or tears.

7. Check for wear or deterioration of the upper or lower

hoses. If there are any portions of the hose that have
been torn or worn through, replace with genuine
Gravely parts.

After Each Use:

1. Clean all debris from machine especially from the

container, underneath the belt shields, and off of
safety decals. Replace any missing or illegible decals.

2. Inspect the unit for worn or damaged components.

Repair or replace before the next use. Any
replacement component installed during repair shall
include the component’s current safety decal specified
by the manufacturers to be affixed to the component.

3. Check belt for proper tension.

Use only white lithium base grease for

lubrication of the shaft on the blower assembly.

1. On initial use: Grease the fitting on the blower shaft.
2. Every 25 hours of use: Re-grease the grease fitting.
3. Every 200 hours of use: Check oil levels in gear box.

Oil in gear box should cover the gears. If not, fill using
an EP90 weight oil. 6oz. will fill the gear box from
empty.

4-2 Lubrication

NOTE:

Model Number

Serial Number

WRITE THE MODEL AND SERIAL NUMBER IN

THE BOX ABOVE FOR FUTURE REFERENCE.

Unit Model Number: ____________________________________________

Unit Serial Number: _________________________________

Date of purchase: ________/_______/________

Dealer/Distributor Name: _________________________________________

Dealer’s/Distributor’s: _______________________ State:___________ Zip:____________

Phone Number: ____________________________

SECTION V

PARTS AND SERVICE

5-1 Parts And Service Information

Gravely collection system owners should record the
name and telephone number of their Service Center.
Your Service Center will be happy to supply replacement
parts, accessories, and do any service or repairs to your
collection system. If for any reason your Service Center
is unable to service your collection system or supply
replacement parts, contact Gravely and include the
following information on the chart below.

THE SERIAL NUMBER PLATE IS LOCATED ON THE

ALUMINUM BOX NEAR THE DUMP HANDLE

GRAVELY

A Division of Ariens Company

655 West Ryan Street

P.O. Box 157

Brillion, WI 54110-0157

920-756-2141

Fax 920-756-2407