Grizzly G0462 - Manual (Page 28)

-26-
g0462 Wood Lathe (mfg. since 3/10)
figure 37. Attaching the faceplate to a backing
block, which is glued to the workpiece.
figure 35. typical faceplate turning operation.
Faceplate turning, as shown in figure 35, is when
a workpiece is mounted to the faceplate that is
then mounted to the spindle. this type of turning
is usually done with open-faced workpieces like
bowls or plates.
3. thread the faceplate onto the spindle and
tighten securely.
Using a backing block
if wood screws cannot be used to attach the face-
plate to the workpiece, then use a backing block
that is securely glued to the workpiece.
To mount your workpiece to a backing block:
1. make the backing block from a piece of scrap
wood that is flat on both sides and free of
knots or splits.
2. Locate and mark the center of both the
workpiece and the backing block.
3. drill a 1 ⁄
4
" hole completely through the center
of the backing block.
4. Looking through the hole in the backing block
to line it up with the center of the workpiece,
glue and clamp the backing block to the
workpiece.
Note: Allow the glue joint to completely cure
according to the manufacturer's instructions.
5. Follow the instructions above to attach the
faceplate to the backing block.
Attaching faceplate to Workpiece
1. mark the center of the workpiece back in
the same manner as in Spindle Turning on
page 24.
Note: Cut off the excess corners of the
workpiece to make it as close to "round" as
possible.
2. use the mark made in Step 1 to center the
faceplate onto the workpiece back, then
attach it with wood screws that do not have
tapered heads (see
figure 37 for an exam-
ple).
NOTICE
DO NOT use screws with tapered heads
to attach the faceplate because they could
split the faceplate, or the screws could
snap off during operation. See the illustra-
tion in figure 36 for examples.
figure 36. Correct screw type for faceplate
attachment.
Correct incorrect
faceplate Turning